Thu Sep 04, 2014 10:34 am
I just put pods on my Alumacraft 15x44 mod v. The reason I put them on my boat is because i am running a long tail mud motor. My problem was with backwash over the transom when slowing down suddenly. Well the pods did the trick and I have no more backwash. I cannot tell a speed difference with my mud motor. It does get on plane faster at just under half throttle vs just over half throttle which is nice. I mounted them so they are tipped a 1/2 in up in the rear. I notice that I lost a little top speed with my 15 hp outboard. The bow does not come up in the front nearly as far as it used to which makes for a wet ride in a chop. I can run shallower with either motor but not by more than an inch or two. If I was not running a long tail mud motor I personally would not waste the money. My boat is better for hunting in shallow slews but it is not better in rough open water. The Pods will end up costing you $250.00 to 500.00 depending on size. If you can not weld aluminum you can add another $100.00 to $200.00 in installation. After tax shipping and installation I had almost $500.00 into my small beavertail pods. It fixed my back splash problem and they work great for me for hunting but not so much for fishing.
I like most things with white cheeks.